ITExamDump의Cisco인증 642-691시험덤프공부가이드 마련은 현명한 선택입니다. Cisco인증 642-691덤프구매로 시험패스가 쉬워지고 자격증 취득율이 제고되어 공을 많이 들이지 않고서도 성공을 달콤한 열매를 맛볼수 있습니다.
ITExamDump의 덤프선택으로Cisco 642-691인증시험에 응시한다는 것 즉 성공과 멀지 않았습니다. 여러분의 성공을 빕니다.
ITExamDump의 Cisco인증 642-691덤프를 구매하시고 공부하시면 밝은 미래를 예약한것과 같습니다. ITExamDump의 Cisco인증 642-691덤프는 고객님이 시험에서 통과하여 중요한 IT인증자격증을 취득하게끔 도와드립니다. IT인증자격증은 국제적으로 인정받기에 취직이나 승진 혹은 이직에 힘을 가해드립니다. 학원공부나 다른 시험자료가 필요없이ITExamDump의 Cisco인증 642-691덤프만 공부하시면Cisco인증 642-691시험을 패스하여 자격증을 취득할수 있습니다.
IT인증자격증만 소지한다면 일상생활에서 많은 도움이 될것입니다. 하지만 문제는 어떻게 간단하게 시험을 패스할것인가 입니다. ITExamDump는 IT전문가들이 제공한 시험관련 최신 연구자료들을 제공해드립니다.ITExamDump을 선택함으로써 여러분은 성공도 선택한것이라고 볼수 있습니다. ITExamDump의Cisco 인증642-691시험대비 덤프로Cisco 인증642-691시험을 패스하세요.
시험 번호/코드: 642-691
시험 이름: Cisco (CCIP BGP + MPLS Exam (BGP + MPLS))
당신이 구입하기 전에 시도
일년동안 무료 업데이트
100% 환불보장약속
100% 합격율 보장
Q&A: 80 문항
업데이트: 2013-09-28
ITExamDump에서는 소프트웨어버전과 PDF버전 두가지버전으로 덤프를 제공해드립니다.PDF버전은 구매사이트에서 무료샘플을 다움받아 체험가능합니다. 소프트웨어버전은실력테스트용으로 PDF버전공부후 보조용으로 사용가능합니다. Cisco 인증642-691덤프 무료샘플을 다운받아 체험해보세요.
ITExamDump의 Cisco인증 642-691시험덤프는 실제시험의 기출문제와 예상문제를 묶어둔 공부자료로서 시험문제커버율이 상당히 높습니다.IT업계에 계속 종사하려는 IT인사들은 부단히 유력한 자격증을 취득하고 자신의 자리를 보존해야 합니다. ITExamDump의 Cisco인증 642-691시험덤프로 어려운 Cisco인증 642-691시험을 쉽게 패스해보세요. IT자격증 취득이 여느때보다 여느일보다 쉬워져 자격증을 많이 따는 꿈을 실현해드립니다.
642-691 덤프무료샘플다운로드하기: http://www.itexamdump.com/642-691.html
NO.1 Which two of the following statements regarding LDP are true? (Choose two.)
A. LDP can also be used between nonadjacent routers using multicast LDP hello messages.
B. LDP does not require periodic hello messages once the LDP session has been established between
the LDP peers.
C. LDP hello messages use TCP packets with a destination port number of 646.
D. Multiple sessions can be established between a pair of LSRs if they use multiple label spaces.
E. Per-platform label space can be identified by a label space ID of 0 in the LDP identifier field.
Answer: DE
Cisco시험문제 642-691 dump 642-691자격증 642-691 642-691
NO.2 In a central services topology, which routes do client VRFs contain?
A. routes from the client site, but not from the server site
B. routes from the server site, but not from the client site
C. routes from both the client site and the server site
D. only EBGP routes from either the client site or the server site
Answer: C
Cisco시험문제 642-691 642-691 dump 642-691 642-691자격증
NO.3 Refer to the diagram.
What problem can be caused by the second P router summarizing the loopback address of the egress PE
router.?
A. The first P router will be faced with a VPN label which it does not understand.
B. The second P router will be faced with a VPN label which it does not understand.
C. The egress PE router will not be able to establish a label switch path (LSP) to the ingress PE router.
D. A label switch path (LSP) will be established from the ingress PE router to the egress PE router, an
event that is not desirable.
E. The ingress PE router will not be able to receive the VPN label from the egress PE router via MP-IBGP.
Answer: B
Cisco 642-691시험문제 642-691최신덤프 642-691 642-691 642-691
NO.4 What does the following command accomplish?
sanjose#clear ip bgp 10.1.1.1 in prefix-filter
A. The sanjose router will perform an outbound soft reconfig to the 10.1.1.1 neighbor.
B. The sanjose router will send out the ORF prefix-list so that a new route refresh will be received from the
1.1.1 neighbor.
C. The 10.1.1.1 router will perform an inbound soft reconfig on the updates from the sanjose neighbor.
D. The 10.1.1.1 router will send out the ORF prefix-list so that a new route refresh will be received from
the sanjose neighbor.
E. The bgp session between the sanjose and the 10.1.1.1 router will be reset so that all the new bgp
updates from the 10.1.1.1 router can be processed by the inbound prefix-list at the sanjose router.
F. The bgp session between the sanjose and the 10.1.1.1 router will be reset so that all the new bgp
updates from the sanjose router can be processed by the inbound prefix-list at the 10.1.1.1 router.
Answer: B
Cisco 642-691 642-691덤프
NO.5 Refer to the exhibit.
\Which two of the following statements about the MPLS configurations are true? (Choose two.)
A. The VPI range being configured is the default VPI range.
B. The router is missing the mpls label protocol ldp configuration command on its ATM 0/0.1 subinterface
to make it an LC-ATM enabled subinterface.
C. There is a problem with the configurations because the control VC should be set to 0 32 instead.
D. The ATM switch is using VC merge since VC merge is enabled by default.
E. For MPLS label allocations, both VPI 6 and 7 can be used.
Answer: DE
Cisco최신덤프 642-691 642-691 642-691시험문제 642-691최신덤프
NO.6 Based on the topology diagram shown in the exhibit, when should BGP be used as the routing protocol
between the customer and the ISP?
A. If physical link failures can not be detected by the link-level procedures.
B. If the customer wants to affect how the ISP will route the customer's traffic out to the rest of the Internet.
C. If the ISP does not support static routing with the customer.
D. If the customer is using provider-assigned (PA) addresses inside the customer's network.
E. If the customer is using private addresses inside the customer's network.
Answer: A
Cisco pdf 642-691 642-691최신덤프 642-691시험문제
NO.7 For which purpose is the command mpls ldp maxhops used?
A. In large ATM-MPLS networks, the LFIB can become too large and it may be necessary to limit the
maximum diameter of the MPLS LSPs.
B. Because downstream-on-demand label allocation uses hop count to control loop detection, it maybe
necessary to limit the maximum diameter of the MPLS network.
C. Because end-to-end delay can cause problems with some voice applications, it may be necessary to
limit the maximum diameter of the MPLS network.
D. When interconnecting large frame mode MPLS and cell mode networks it may be necessary to limit the
maximum network diameter to prevent forwarding loops.
Answer: B
Cisco자격증 642-691 642-691 642-691
NO.8 Based on the network diagram shown in the exhibit, what is the correct configuration on the customer
edge router used to conditionally announce the customer networks to the ISP?
A. router bgp 65001
! neighbor commands not shown
network 192.168.8.0 mask 255.255.252.0
!
ip route 192.168.8.0 255.255.252.0 192.168.8.33
B. router bgp 65001
! neighbor commands not shown
aggregate-address 192.168.8.0 255.255.252.0 summary-only
!
ip route 192.168.8.0 255.255.252.0 192.168.8.33
C. router bgp 65001
! neighbor commands not shown
network 192.168.8.0
network 192.168.9.0
network 192.168.10.0
network 192.168.11.0
!
ip route 192.168.8.0 255.255.255.0 null0
ip route 192.168.9.0 255.255.255.0 null0
ip route 192.168.10.0 255.255.255.0 null0
ip route 192.168.11.0 255.255.255.0 null0
D. router bgp 65001
! neighbor commands not shown
aggregate-address 192.168.8.0 255.255.252.0 summary-only
!
router ospf 1
network 192.168.8.0 0.0.3.255 area 0
E. router bgp 65001
! neighbor commands not shown
aggregate-address 192.168.8.0 255.255.252.0
!
ip route 192.168.8.0 255.255.252.0 null0
Answer: A
Cisco시험문제 642-691덤프 642-691덤프
NO.9 On a dedicated subinterface implementation, PE-2 must establish an address-family vrf IPv4 BGP
neighbor relationship with which router?
A. CE-1
B. CE-2
C. PE-1
D. PE-IG
E. CE-1 and CE-2
F. PE-1 and PE-IG
Answer: B
Cisco dump 642-691 642-691 642-691덤프 642-691자료 642-691시험문제
NO.10 What are three drawbacks of a peer-to-peer VPN using a shared provider edge (PE) router? (Choose
three.)
A. A full mesh of virtual circuits is required between the customer sites.
B. All the customers have to share a common IP address space.
C. Optimal routing between customer sites cannot be guaranteed.
D. The shared PE router has to know all routes for all customers.
E. Packet filters are required on the PE routers.
Answer: BDE
Cisco자격증 642-691 dumps 642-691
ITexamdump의 70-583덤프의 VCE테스트프로그램과 VCP510-DT덤프는 한방에 시험을 패스하도록 도와드립니다. ITexamdump 에서는 최신버전의 HP2-N40시험에 대비한 고품질 덤프와 C_TSCM62_65시험 최신버전덤프를 제공해드립니다. 최고품질 ACMA_6.1시험자료는 100% 간단하게 시험패스하도록 최선을 다하고 있습니다. IT인증시험패스는 이토록 간단합니다.
댓글 없음:
댓글 쓰기